Usually troubleshooting of laser cutting engraving system

1)The laser is on and off at work    
1.Check whether the water cycle is ok
2.whether the supply voltage is stabilize
Method :
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply

2)Theonline data can’t be disposed
1.whether the communication cable is connected
2.whether the software USB is  installed
Method :
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive

3)Processing size does not  consistent with software set
1.Install the software
2.Adjust action
Method:
1.install the ...

Continue Reading →
0