Customer from Mexico for heavy Duty CNC cutting equipment
HBCNC-6000X16000X1C+1A
Size 6000x16000mm
One plasma and one flame torch
Maxpro200 plasma supply
MAY
Customer from Mexico for heavy Duty CNC cutting equipment
HBCNC-6000X16000X1C+1A
Size 6000x16000mm
One plasma and one flame torch
Maxpro200 plasma supply
Customer from Isreal for Liner rail Heavy duty CNC cutting machine:
Heavy duty cutting machine 4000x14000mm size
One plasma and one flame cutting torch
Maxpro200
Liner rail.
Fault Symptoms | Fault Check | Fault Analysis | Recommended Solutions |
Suddenly breakdown in normal operation | Always stop at the same position in every operation cycle | a. Machining program at fault
b. CNC software at fault |
Dispatch the software back to the manufacturer for professional troubleshooting. |
The system still runs but the cutting torch stops abnormally along all axes or one axis. | a The travel motor is locked.
b The travel motor fails. |
Check if the machine is frozen and ... |
1)The laser is on and off at work
1.Check whether the water cycle is ok
2.whether the supply voltage is stabilize
Method :
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply
2)Theonline data can’t be disposed
1.whether the communication cable is connected
2.whether the software USB is installed
Method :
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive
3)Processing size does not consistent with software set
1.Install the software
2.Adjust action
Method:
1.install the ...